The survey found that the majority of steel metal hose their nets have different degrees of damage. The use of a butt weld metal hose made of stainless steel strip nets, the net addition of sets of strips in the damage at the weld site. Select the hose should be noted that selection depends on what the number of centimeters to consider settlement, and then select the length, the basic DN200 * 1000MM, only settlement 30MM, the greater the diameter, the longer the hose should be chosen, should be considered if the DN400 L 2000MM. Bellows do not forget to choose a large lever bellows tank, and should also consider the length of the product, should be considered if the DN400 L 2500MM.

Water Inlet Hoses.Extreme care should be taken when attaching the water inlet hoses to the washer inlet valves with nylon bodies. Cross threading of these hose couplings on the valve inlets can cause leaks and can damage the threads. Do not over tighten. A filter washer screen is provided for each hose and is to be installed cup side up in the shoes end that is to be attached to the faucet. A standard rubber washer is provided for use in the end that attaches to the valve. Two 3/8 inch inside diameter rubber molded or reinforced stainless hose is used to carry the water from the water supply valve to a water inlet valve of washing machine.

Fill Control Hose.The fill control hose and recirculation inlet hose are secured to the tub by special internal retaining rings that can be removed by use of regular or needle-nose pliers. The reducing connector that couples the fill control hose to the plastic tubing should be tightly secured to the inside of the fill control hose by use of rubber cement.

Recirculation Hoses.On many washers here are two hoses used to recirculation the water from the outer tub through the recirculation pump and through the filter at the top of the tub. The hose between the tub and the pump is attached to a plastic side outlet assembly which is secured to the tub side by a locking ring. The other hose runs from the outlet of the recirculation pump to the filter housing. Because the filter housing is secured to the top, the recirculation hose must be removed to raise the top for servicing.

Pump Outlet Hose.On machines that do not have a two-way valve, the hose runs from the pump outlet to a hole in the rear of the cabinet and is secured to a hose coupling by a hose clamp. On machines equipped with a two-way valve, the hose runs from the pump outlet to the inlet on the two-way valve.

 

Source: plastic hose, stainless steel hose