Sitemap XML
Set Home Email Us 0086 574-62465290
Lightweight Race Hose and Car's Performance
Home >> News >> Removing Scratches: Stainless Steel Handrails
News
Removing Scratches: Stainless Steel Handrails
April 25, 2011
 

The hose, that may have been on the yard floor or pontoon, will have picked up grit; this grit along with the hose, scratches the stainless as it is pulled back and forth over the handrail.To prevent this... clean the hose off before use, then place enough hose length on board for the wash. This way you will not be pulling the hose back and forth over the rails. Where the hose does meet the stainless, tie off with a cloth.Forget starting with metal polish, as it will only remove the very lightest of scratches. What you need is various grades of extra fine wet & dry sandpaper and some water, with a few drops of soap in to act as a lube.Depending on the depth of the scratches (some may be just too deep) 600, 800, 1200 & 2500 would be a good selection. Follow with finer and finer grades until a reflection is formed.Try with the finest you have to start with and only use a coarser grade if that fails to 'flat' them.

 


Source: stainless steel hose  

 

[Home] [Print] [Back]

Contact Us

  • Tel:

    0086 574-62465290
  • Chat Online:

  • Email:

    sales@nbjinxing.com
  • WebSite:

    www.nbjinxing.com
Back Top

Rss Site Map Feedback Add Favourite

solar mounting parts, Foot anchor, Heat Pump, Household Heat Pump, Construction Machinery Parts, heavy machinery parts, steel casting part, investment casting, Reflective Clothing, Workwear Clothing, PVC Film, PVC Floor Covering, Monocular Telescope, Promotional Binoculars, Linear Bearing, Flanged Linear Bearing, Ball valves, Angle Valves, Pneumatic component, Air treatment units, Auto Bins, Sensor Trash Cans, PTFE open meshes, PTFE civil products, refrigeration ball valve, frozen ball valve, PU promotional gifts, PU stress balls